Friday , April 3rd 2020
    Best Deals On Everything

How To make a DIY Electronics Work Bench – Part 3

How To make a DIY Electronics Work Bench – Part 3
This post contains affiliate links for products we recommend, affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com. As an Amazon Associate the site earn from qualifying purchases  If you click a link and buy something we may receive some compensation. This does not change the price you would pay.

At present on Made To Hack, I in the end setup my electronics workbench in part 2, I had completed the lights and the electrical on this final part three of this series, I setup all my gear and instruments I first convey in my resistors cupboard as it’s going to take one nook I smooth my hot air rework station and soldering iron I measure and tape out an discipline as a reference for my ESD mat I then deliver in and set up my Rigol DS1054Z oscilloscope I bring in my hacked solderless breadboard from a prior video I unpack and roll out my anti-static ESD protection mat To the incorporated female press stud, I solder and heat reduce a 1 Meg Ohm resistor And to it I solder a size of wire partly 2 of this sequence, I had left uncovered a section of wire related to floor This used to be now tinned and to it soldered the wire coming from the press stud With the wire warmth shriveled, it was once router in the back of all the equipment and the clicking stud used to be linked to the ESD mat I heated up my soldering iron to 390 levels celsius The ESD Mat is rated to withstand up to four hundred levels celsius I touched the mat with my soldering iron to peer if it is resistant right here you can see the top resistive layer and the backside conductive layer of the ESD mat simply above my oscilloscope, I stuck and stapled a size of hook and loop fastener, ie Velcro To each one among my multimeters, I stuck the other half of of the Velcro strip The multimeters were then positioned in situation above my oscilloscope To the left of my resistors cabinet, I screwed in some screws to the top shelf i use these to hang more than a few experiment leads and vigour cables And here it is, the subsequently complete electronics workbench it’s already establishing to get cluttered as is to be anticipated i’m hoping you get stimulated via my workbench and build your possess Share your ideas on this undertaking within the feedback below